Changes for page 3D printed toy train

Last modified by Victor Zhang on 00:33, 22/07/2020
From version < 16.1 >
edited by Victor Zhang
on 23:55, 18/12/2019
To version < 14.2 >
edited by Victor Zhang
on 23:48, 18/12/2019
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -8,15 +8,11 @@
8 8  ** [[The L293DD H-Bridge board to fabricate and The sketch to run on MH-ET Live ESP32 Kit>>https://bitbucket.org/victorzzt/bleesp32train/src/master||target="_blank]]
9 9  * Other parts needed
10 10  ** Screws and nuts:
11 -*** m2x6 8pcs
12 -*** m2x25 4pcs
13 -*** m2x10 1pc
14 -*** m2x30 2pcs
15 -*** m2 Nuts 15pcs
16 -** Shafts
17 -*** m2 x 30 1pc, m2 x 40 1pc
18 -** Shaft clipper
19 -[[image:ShaftNuts.jpg||alt="ShaftNuts" height="133" width="200"]]
11 +*** m3x6 8pcs
12 +*** m3x25 4pcs
13 +*** m3x10 1pc
14 +*** m3x30 2pcs
15 +*** m3 Nuts 15pcs
20 20  ** GA12-N20 (Use 6V, the one in the picture is hard to find, needs to grind the shaft down to M2 x 8mm)
21 21  [[image:Motor.jpg||alt="Motor,Motor.jpg" height="407" width="400"]]
22 22  ** C15-2A
Charger.jpg
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.victorzzt
Size
... ... @@ -1,1 +1,0 @@
1 -42.9 KB
Content
ShaftNuts.jpg
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.victorzzt
Size
... ... @@ -1,1 +1,0 @@
1 -4.8 KB
Content

Navigation